FREE shipping on orders over $199 in the continental U.S.Most items — see details

Rear Wing Endplate, 19″ Tall, USF2000 style for DP08 & Van Diemen ’90-up

$94.65

The USF2000 modified 19″ tall endplate (part number 14B2015) is made in the style of the original USF2000 series rear wing endplate design for Elan DP08 cars — but 1″ shorter than part number DP08-47-016.

  • Made from 6061 T6 aluminum with a black anodized finish, similar construction as DP08-47-016.
  • 19″ tall and 11″ wide — 1″ shorter than DP08-47-016.
  • A little thinner and lighter weight than the original USF2000 design endplate DP08-47-016.
  • Bottom holes are cut for large lower wing element 20B2018 that was used in the USF2000 series for the DP08 cars that uses the swan neck type wing brackets, though many different cars can use these end plate with minimal additional drilling of the endplate.
  • Not handed; will fit either left or right side.
  • No teardrop insert or other profiles and no outboard gurney flaps.
  • Sold individually.
  • Part # 14B2015.

USF2000 Design Endplate Specifications

Material 0.1″ or 2.5mm thick 6061 T6 aluminum, black anodized
Height 19″ (1″ shorter than  DP08-47-016.)
Width 11″
Weight 1.95 lb
SCCA FC legal Yes- Current GCR says the “Maximum wing height measured from the ground with the driver on board is 90cm.” This end plate is 19″ tall versus the other option of 20″ tall with part DP08-47-016.

USF2000 Design Endplate Application:

  • Elan DP08 & Van Diemen ’90-up
  • Other formula cars using swan-neck type rear wing brackets, with minor drilling as needed