FREE shipping on orders over $199 in the continental U.S.Most items — see details

Rear Wing End Plate, 20″ Tall, USF2000 Design for DP08 & Van Diemen ’90-up

$59.45

The USF2000 OEM endplate (part number DP08-47-016) is the original USF2000 series rear wing endplate design for Elan DP08 cars — 1″ taller than part number 14B2015.

  • Made from 6061 T6 aluminum with a black anodized finish, similar construction as 14B2015.
  • 20″ tall and 11″ wide — 1″ taller than 14B2015‘s 19″ height, following the original USF2000 series design.
  • Potentially not legal for SCCA Formula Continental (FC) use — this taller design often positions the rear wing higher than current SCCA regulations allow depending on the height of your pylons. It was legal under the original USF2000 series rules. GCR currently reads: Maximum wing height measured from the ground with the driver on board is 90cm (for Formula Continental)
  • Bottom holes are cut for large lower wing element 20B2018 that was used in the USF2000 series for the DP08 cars that uses the swan neck type wing brackets, though many different cars can use these end plate with minimal additional drilling of the endplate.
  • Not handed; will fit either left or right side.
  • No teardrop insert or other profiles and no outboard gurney flaps.
  • Sold individually.
  • Part # DP08-47-016.

USF2000 Design Endplate Specifications

Material 0.125″ or 3.12mm thick 6061 T6 aluminum, black anodized
Height 20″ (1″ taller than 14B2015)
Width 11″
Weight 2.6 lb
SCCA FC legal Maybe, depending on specific wing design and ride height– Current GCR says the “Maximum wing height measured from the ground with the driver on board is 90cm.” This end plate is 20″ tall versus the other option of 19″ tall with part 14B2015

USF2000 Design Endplate Application:

  • Elan DP08 (original USF2000 series configuration) and Van Diemen ’90-up
  • Other formula cars using swan-neck type rear wing brackets, with minor drilling as needed