Terry Body Spring or Bonnet Fastener (Stainless), 136mm or 5.4″ Length

These well proven spring fasteners are one of the best ways to hold noses, fenders or other pieces of bodywork to a race car:

• They allow the body panels to take a little “bumping” since the springs can stretch and then pull the part back into place.
• Perfect for vintage cars looking for an authentic and traditional bodywork hold down method.
• They are easy to install and disconnect by hand given the ergonomic design of the finger hook.
• Stainless steel construction will not chip or rust.
• Approximately 3-3/4″ from the center of the mounting bolt to the edge of the hook hole when spring is relaxed.
• Hook mounting hole diameter: 9/16″.
• Sold individually.
• Part number 72260. Alternate part number: 3001
• Compatible with hold down hook F77259-2.